Linkage Stop

Lenny5160 · 09-10-2020, 11:54 AM

Even in my dragster I struggled to cut a light with the stop coming on earlier than 0.100. I use a linkage stop with no flow controls going all the way to dead idle, so maybe that has a little something to do with it.

pmrphil · 09-10-2020, 12:57 PM

The inertia from the rotating mass should be enough to launch the car, unless it's at too low of an RPM or chipped too far from the converter stall point. But there's always variables.

09-10-2020, 11:54 AM	#1
Lenny5160 Senior Member Join Date: Nov 2015 Location: Inver Grove Heights, MN Posts: 898 Likes: 604 Liked 431 Times in 224 Posts	Re: Linkage Stop Even in my dragster I struggled to cut a light with the stop coming on earlier than 0.100. I use a linkage stop with no flow controls going all the way to dead idle, so maybe that has a little something to do with it. __________________ S/ST 51 S/C 53

09-10-2020, 12:57 PM	#2
pmrphil Member Join Date: Aug 2010 Location: CT Posts: 457 Likes: 1,796 Liked 347 Times in 151 Posts	Re: Linkage Stop The inertia from the rotating mass should be enough to launch the car, unless it's at too low of an RPM or chipped too far from the converter stall point. But there's always variables. __________________ Phil Molski PMR Performance S/C 1623

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode