Uneven flexplate to converter gap

pmrphil · 10-09-2020, 08:49 AM

That strikes me as a bellhousing issue, possibly not square? Shouldn't be too hard to measure it.

70 Stang · 10-09-2020, 07:31 PM

Thanks Phil, I'm going to pull the trans and remove the bellhousing tonight. I'm hoping to find something obvious, like part of the case that needs a little more material removed. Will take some measurements too and see where it's at. Will let you know whatIi find.

Brian

10-09-2020, 08:49 AM	#1
pmrphil Member Join Date: Aug 2010 Location: CT Posts: 456 Likes: 1,796 Liked 346 Times in 150 Posts	Re: Uneven flexplate to converter gap That strikes me as a bellhousing issue, possibly not square? Shouldn't be too hard to measure it. __________________ Phil Molski PMR Performance S/C 1623

10-09-2020, 07:31 PM	#2
70 Stang Junior Member Join Date: Oct 2020 Posts: 2 Likes: 0 Liked 1 Time in 1 Post	Re: Uneven flexplate to converter gap Thanks Phil, I'm going to pull the trans and remove the bellhousing tonight. I'm hoping to find something obvious, like part of the case that needs a little more material removed. Will take some measurements too and see where it's at. Will let you know whatIi find. Brian

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode