H-I-J '76 Nova re-fit.

[Glenn Briglio]

Originally Posted by Nmbr1GMfan

We got it all wrapped up this morning, fired off on the first click of the starter, ran it for 30 seconds and re-checked the valves and found 1 that needed tightened up. Big difference in this setup and oiling to the top VS the last setup. Ran cam break-in for 30 minutes, tomorrow morning I'll check on the new driveshaft and at some point we'll swap rockers.

What's different about oiling system ? New camshaft ? Ran on dyno with new cam ?

[Nmbr1GMfan]

Originally Posted by Glenn Briglio

What's different about oiling system ? New camshaft ? Ran on dyno with new cam ?

Lifters are different.

[Frank Castros]

Sounds great and the car is magnificent!

[MR DERBY CITY]

This is a first class build ...my only disappointment is that whatever TOOL that was used to cut the rear carpet around the roll bar.....it needs to be retired....or better yet...send it to HP HUNTER ....

[Nmbr1GMfan]

Took a trip to https://pstds.com/ in Clearwater this morning, they are great to deal with, helped me figure out what I needed and got it done real quick at a reasonable price. Thanks Ron@PST.

[HP HUNTER]

Originally Posted by MR DERBY CITY

This is a first class build ...my only disappointment is that whatever TOOL that was used to cut the rear carpet around the roll bar.....it needs to be retired....or better yet...send it to HP HUNTER ....

Not everybody is a sewing mavern there MJ.........Good luck Todd........you ain't no quitter, lets see that thing fly!

[Nmbr1GMfan]

Originally Posted by HP HUNTER

Not everybody is a sewing mavern there MJ.........Good luck Todd........you ain't no quitter, lets see that thing fly!

I'm not sure it'll fly... I'd settle for improvement.

[Larry Hill]

Over 1/2 Million Views and most of us can't wait for the next post.

[Nmbr1GMfan]

Originally Posted by Frank Castros

Sounds great and the car is magnificent!

Thanks Frank.