Dual Point Corvette Distributor

[Mark Ruset]

Looking for a set of points for my dual point distributor, anyone have any leads or part numbers. The distributor is cast iron early corvette and has the tach drive.
Thanks

[MR DERBY CITY]

Originally Posted by Mark Ruset

Looking for a set of points for my dual point distributor, anyone have any leads or part numbers. The distributor is cast iron early corvette and has the tach drive.
Thanks

Back in the day, D112P was the Delco part number we all used ….tell me you are not using this in your stocker……

[Roberte]

NAPA has them.
Bob

[prostockpete1]

fyi .. the Holley website shows their Accel ignition division shows a heavy duty / strong spring pressure points / condenser / clamp part # available for gm distributors

[Adger Smith]

If my memory is doing right I think the best set back in the day were made by Mallory.
Think they had an X in the part number. for extra spring tension.
Sure beat doing the double spring modification.

[Henrys Toy]

Originally Posted by Adger Smith

If my memory is doing right I think the best set back in the day were made by Mallory.
Think they had an X in the part number. for extra spring tension.
Sure beat doing the double spring modification.

Good morning,
I believe the Good Accel points were #110129 and the regular Street points were #110128.
The Mallory points were #102X - these were the Heavy Duty race points they would go 10,000 RPM on my old Sunnen Distributor machine. I used the old Accel #110129 points till I couldn't get them anymore, are they still available under a different part? Thanks in advance.

Respectfully,
Henry Kunz 1534 H/SA

[Mark Ruset]

Originally Posted by MR DERBY CITY

Back in the day, D112P was the Delco part number we all used ….tell me you are not using this in your stocker……

No it's not for my stocker, Have a 1967 Camaro street car was looking to freshen up the distributor. The car was put back on the street in 1999 and haven't done anything since then to it, Thanks for the part number

[Mark Ruset]

Originally Posted by Roberte

NAPA has them.
Bob

Thanks I'll check them out

[MR DERBY CITY]

Originally Posted by Mark Ruset

No it's not for my stocker, Have a 1967 Camaro street car was looking to freshen up the distributor. The car was put back on the street in 1999 and haven't done anything since then to it, Thanks for the part number

OK, you are good to go then Mark,….LOL ….