|
04-24-2024, 08:21 PM | #41 |
Member
Join Date: Jul 2006
Location: South Dakota
Posts: 142
Likes: 65
Liked 332 Times in 51 Posts
|
Re: 402 stocker engine
Hi Jim -- when you say an oil temp problem , what do you mean ?? is it get hot fast and do you know how hot ?? or what is it doing ?? not trying to snoop just very interested in your problem . Bob
|
04-24-2024, 10:09 PM | #42 |
Member
Join Date: May 2020
Posts: 395
Likes: 393
Liked 357 Times in 179 Posts
|
Re: 402 stocker engine
So since you say you have re ringed it couple times, I'm going to assume the pistons and rod bearings are ok, have you had a peek at the main bearings?
If it's smoking it can only be blow by or something with enough friction to get the oil hot enough to smoke,,, There's only a few things that can make heat... And I would think anything hot enough to cause the oil to get that hot it will leave evidence. It's defiantly oil smoke, not steam (cracked block)? Just thinking out loud... |
Liked |
04-25-2024, 06:21 PM | #43 |
Junior Member
Join Date: Dec 2021
Location: Pukwana SD
Posts: 53
Likes: 172
Liked 5 Times in 5 Posts
|
Re: 402 stocker engine
Bob no the engine doesn’t get hot check the oil temp it’s leads the water temp about 25 to. 30 degrees . I ran the engine last year never got over 170 180.
|
04-25-2024, 09:00 PM | #44 |
Member
Join Date: Nov 2016
Location: Indianola Washington
Posts: 359
Likes: 0
Liked 396 Times in 126 Posts
|
Re: 402 stocker engine
I would consider changing the Oil to Maxima break in Oil and then put a load on the motor in the car a couple of times, letting it cool down in-between and see if this changes the breather oil smoke condition.
Steve Teeter Stk/SS 620 |
04-26-2024, 06:48 PM | #45 |
Junior Member
Join Date: Dec 2021
Location: Pukwana SD
Posts: 53
Likes: 172
Liked 5 Times in 5 Posts
|
Re: 402 stocker engine
How warm should the engine be? Before the shut down?
|
04-26-2024, 07:53 PM | #46 |
Member
Join Date: Nov 2016
Location: Indianola Washington
Posts: 359
Likes: 0
Liked 396 Times in 126 Posts
|
Re: 402 stocker engine
I assume it's an Automatic?
Get the motor up to 120-130 on jack stands. In gear , hold the brake , put it on the Convertor to load the motor maybe 5 6 seconds. 180- 190 temps cool it repete. Or take to the track and make 2 WOT hits. Again, suggest that you use Maxima break in Oil. Where is the timing set at? Locked out distributor advance? I would be very conservative with it. BB 402 Stocker start with 32 33 degrees go from there. |
04-27-2024, 08:55 AM | #47 | |
Member
Join Date: Oct 2017
Location: Bay City Texas
Posts: 358
Likes: 1
Liked 202 Times in 123 Posts
|
Re: 402 stocker engine
When you doing all this have a blowby meter hook up to it. When we had our B-Dragster you could spin the starter and if the float moved in the tube there was blowby!
Quote:
|
|
|
|