lifter metering plates

Run to Rund · 10-06-2015, 10:44 PM

I am using solid lifters with 0.520" OD, 0.015" thick oil feed metering plates (for the pushrods-rockers) that have four offset holes in them. I would like to find plates with no hole or with a single small, offset hole. Does anyone know where I might find some, or what lifter might come with what i need in it.

Mike Taylor 3601 · 10-07-2015, 01:41 PM

I made some recently out brass shim stock using gasket punch,if you have room sandwich it in with existing plates.
I used .005 thick most likely you will need to cut small groove in plate you have now so oil can get through.
The ones I did once the were in there they couldn't get out.
Mike Taylor 3601

10-06-2015, 10:44 PM	#1
Run to Rund Senior Member Join Date: Sep 2007 Posts: 574 Likes: 6 Liked 44 Times in 22 Posts	lifter metering plates I am using solid lifters with 0.520" OD, 0.015" thick oil feed metering plates (for the pushrods-rockers) that have four offset holes in them. I would like to find plates with no hole or with a single small, offset hole. Does anyone know where I might find some, or what lifter might come with what i need in it.

10-07-2015, 01:41 PM	#2
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,303 Likes: 198 Liked 116 Times in 48 Posts	Re: lifter metering plates I made some recently out brass shim stock using gasket punch,if you have room sandwich it in with existing plates. I used .005 thick most likely you will need to cut small groove in plate you have now so oil can get through. The ones I did once the were in there they couldn't get out. Mike Taylor 3601