|
10-06-2015, 10:44 PM | #1 |
Senior Member
Join Date: Sep 2007
Posts: 574
Likes: 6
Liked 44 Times in 22 Posts
|
lifter metering plates
I am using solid lifters with 0.520" OD, 0.015" thick oil feed metering plates (for the pushrods-rockers) that have four offset holes in them. I would like to find plates with no hole or with a single small, offset hole. Does anyone know where I might find some, or what lifter might come with what i need in it.
|
10-07-2015, 01:41 PM | #2 |
VIP Member
Join Date: Oct 2008
Location: Somerset,Ky
Posts: 1,303
Likes: 198
Liked 116 Times in 48 Posts
|
Re: lifter metering plates
I made some recently out brass shim stock using gasket punch,if you have room sandwich it in with existing plates.
I used .005 thick most likely you will need to cut small groove in plate you have now so oil can get through. The ones I did once the were in there they couldn't get out. Mike Taylor 3601 |
|
|