|
05-24-2015, 11:15 AM | #1 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
engine run on
Parked the car last fall everything is fine, Start it yesterday and now when you click it off it runs for several second before it shut off. I have checked the grounds, does not have a alternater, When I put a test light on the ing switch it stops like it should .Has a ARC switch panel. Anyone Jim Hanig
|
05-24-2015, 11:35 AM | #2 | |
VIP Member
Join Date: Apr 2012
Location: Connecticut
Posts: 1,110
Likes: 1,166
Liked 660 Times in 283 Posts
|
Re: engine run on
Quote:
With the engine idling, you could unplug the ign. box to kill it. Should stall immediately That should point the way Turn the key off before you plug it back in. I don't believe you would damage your particular ign. system, but you will have to decide that. Good luck Mike A114 P/SA Last edited by Mike Jones; 05-24-2015 at 11:38 AM. |
|
05-24-2015, 12:02 PM | #3 |
Junior Member
Join Date: Jun 2005
Location: Albert Lea, MN
Posts: 46
Likes: 2
Liked 16 Times in 7 Posts
|
Re: engine run on
Electric fan backfeed? No relay?
|
05-24-2015, 06:07 PM | #4 |
Senior Member
Join Date: Aug 2004
Location: So. Cal.
Posts: 651
Likes: 4
Liked 54 Times in 33 Posts
|
Re: engine run on
Fresh fuel? Race gas dies quickly compared to street pump gas. Had this experience 25 years ago.
|
05-24-2015, 06:37 PM | #5 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
Re: engine run on
|
05-24-2015, 06:43 PM | #6 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
Re: engine run on
The fuel is a week old
|
05-24-2015, 06:45 PM | #7 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
Re: engine run on
Does the panel need to be grounded? It is screwed to the plastic dash ?
|
05-24-2015, 06:51 PM | #8 |
Senior Member
Join Date: Jun 2007
Posts: 750
Likes: 377
Liked 247 Times in 78 Posts
|
Re: engine run on
Jim
Just had the same happen to me after doing a cam swap. I normally kill the motor by shuting off the fuel pump, never had a problem until then. Engine slowly loses rpm put stays running for 10 seconds. Fuel pressure is slowing dropping from 65psi but still registers on regulator. What brand of fuel are you running??? RJ |
05-25-2015, 11:00 PM | #9 |
Member
Join Date: Aug 2002
Location: Pierre, SD
Posts: 199
Likes: 0
Liked 25 Times in 13 Posts
|
Re: engine run on
Jim, did you check the relay? The contacts may have corroded over the winter and then it may have welded itself on during the first use.
__________________
Dean Feiock -- Stock 5002 |
05-27-2015, 11:22 AM | #10 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
Re: engine run on
Well heres one for you I got al set to redo the wireing ,start the car and guess what it quit s like it suppose to.
|
|
|