|
07-22-2014, 09:47 PM | #1 |
Senior Member
Join Date: Jun 2012
Posts: 607
Likes: 479
Liked 831 Times in 185 Posts
|
Pinion angle
What is the desired pinion angle, '91 Camaro Stocker, A.T.?
Thanks in advance for your replies. J.R. |
07-22-2014, 11:54 PM | #2 |
Veteran Member
Join Date: Mar 2002
Location: Miles From Nowhere
Posts: 7,393
Likes: 2,563
Liked 4,419 Times in 1,683 Posts
|
Re: Pinion angle
sorry ...was thinking 81 Camaro ..no comment..carry on
__________________
We are lucky we don't get as much Government as we pay for..... Will Rogers |
07-23-2014, 08:42 AM | #3 |
Member
Join Date: Oct 2003
Location: Lower Slower Delaware
Posts: 492
Likes: 14
Liked 198 Times in 73 Posts
|
Re: Pinion angle
The desired pinion angle going down track should be as close to zero as possible at all angles for front and rear u-joints.
Put the front of the torque arm where it will be going down track and adjust to be as close as possible. The engine is offset to the right so be sure to look at those angles also.
__________________
Frank Ferrucci ?/SA 1271 |
07-23-2014, 07:36 PM | #4 |
Senior Member
Join Date: Jun 2012
Posts: 607
Likes: 479
Liked 831 Times in 185 Posts
|
Re: Pinion angle
Thanks Frank. That info will be very helpful. J.R.
|
07-24-2014, 03:12 PM | #5 |
Member
Join Date: Aug 2003
Location: Atlanta
Posts: 474
Likes: 15
Liked 69 Times in 20 Posts
|
Re: Pinion angle
Frank
On a Mopar the engine is also offset to the right as is the pinion. Is the pinion in the Camaro offset also? How far off center is the engine/pinion? Just curious.
__________________
Stewart Way 2424 SS |
07-25-2014, 05:19 PM | #6 |
Member
Join Date: Oct 2003
Location: Lower Slower Delaware
Posts: 492
Likes: 14
Liked 198 Times in 73 Posts
|
Re: Pinion angle
It's years since I did that measurement when building my stocker but 5/8" to the right is a recollection. Depending on what rear housing you put in it pinion location may not be where it needs to be relative to the trans. yoke. It's worth checking if your looking for maximum or near as possible efficiency.
__________________
Frank Ferrucci ?/SA 1271 |
07-25-2014, 06:45 PM | #7 |
Veteran Member
Join Date: Mar 2002
Location: Miles From Nowhere
Posts: 7,393
Likes: 2,563
Liked 4,419 Times in 1,683 Posts
|
Re: Pinion angle
Pinion is offset 1'' in a factory 12 bolt. This is how you are able to use the same length axles both sides
__________________
We are lucky we don't get as much Government as we pay for..... Will Rogers |
Thread Tools | |
Display Modes | |
|
|