|
03-27-2017, 08:01 AM | #11 |
Member
Join Date: Dec 2013
Posts: 311
Likes: 2
Liked 9 Times in 8 Posts
|
Re: Small block ford crank scraper
Moroso 22939
Milodon 32222 both are nice windage trays but you need to make your own scraper its not hard get some cardboard and make a template and get after it. The oiling system of a Ford Cleveland needs major work, up above is just a start, and I know guys will say they did this and they did that but the fact is... to make any kind of power and make it last while restricted to a stock pan takes work
__________________
__________________ Bill Diehl B200 C/D STK |
03-27-2017, 09:32 AM | #12 |
VIP Member
Join Date: Feb 2014
Location: Lakewood Washington
Posts: 1,407
Likes: 29
Liked 236 Times in 127 Posts
|
Re: Small block ford crank scraper
I have the following windage tray on my BOSS block 302:
https://www.summitracing.com/parts/c...view/make/ford It required a bolt kit for a 351 due to the 1/2 in main caps and a little hammer time to fit just right. The motor has been fired and hasn't spit anything out.
__________________
Dale Shearon 68 Mustang 6394 Last edited by FireSale; 03-27-2017 at 09:40 AM. |
Thread Tools | |
Display Modes | |
|
|