Torque wrench

[astikhossw]

Where do you guys get the torque wrench that measure down to 5 inch pounds to set pinion pre load.I have been looking online and have not found one will go that low.

[Rob Petrie E395]

Originally Posted by astikhossw

Where do you guys get the torque wrench that measure down to 5 inch pounds to set pinion pre load.I have been looking online and have not found one will go that low.

I will look and check for sure when I get back to the shop. But I think mine is a KD 2955. Its 1/4 inch drive. So I welded a old 1/4 socket to a socket I use when checking preload. That way I don't have to use several adapters to get there. I dont remember where I got mine as I have had it for 15-20 years but they are available online through many places.
Hope this helps
Rob

[Dwight Southerland]

Get a dial type or a beam type rather than a clicker. You can't get it right with a clicker.


http://www.modernbike.com/product-21...FW4V7AodpF4A-Q


http://www.craftsman.com/search=inch...orque%20wrench


http://shop.advanceautoparts.com/p/k...955/22988238-P

[astikhossw]

Ok thanks I was looking for the clicker type,So the dail or beam types or better for checking pinion preload.

[Paul Precht]

Originally Posted by astikhossw

Ok thanks I was looking for the clicker type,So the dail or beam types or better for checking pinion preload.

You'll need the dial type because you have to keep it rotating to get an accurate reading of the pinion preload.

[Dwight Southerland]

Originally Posted by Paul Precht

You'll need the dial type because you have to keep it rotating to get an accurate reading of the pinion preload.

Yes. Breakaway torque is much higher than the resistance torque.

[tj310]

Snap on gte12a dial type ,I've had it a long time pretty well all its used for ...Trevor