|
05-23-2017, 08:05 AM | #1 |
Junior Member
Join Date: Jan 2009
Location: Columbus, OH
Posts: 97
Likes: 0
Liked 2 Times in 1 Post
|
Global West Bushing - weld or not?
I've installed the Global West lower control arm bushing for the 4th gen firebird, the instructions they provide says to weld them into the control arm. Is this more of a CYA liability thing or do I need to get them welded? Would the control arm actually move on the bushing?
|
05-23-2017, 07:52 PM | #2 |
Member
Join Date: Dec 2006
Location: Cocoa Florida
Posts: 200
Likes: 173
Liked 71 Times in 35 Posts
|
Re: Global West Bushing - weld or not?
I installed Global West Bushings on my 67 Nova. I had to press all of the bushing in, they all fit pretty tight. I didn't think they needed to be welded. If they needed to be welded I would have only tack them in a couple of places not a full pen weld. Plus in your case they may be in certain places where Global West have found out from custormers they may have had problems and the fix was to weld the bushing in place. In my case the bushings were press fit and I was satisfied with all the parts I bought from them. Kenney Kelley
. |
05-23-2017, 07:54 PM | #3 |
Senior Member
Join Date: Sep 2016
Posts: 838
Likes: 150
Liked 276 Times in 151 Posts
|
Re: Global West Bushing - weld or not?
Don't think it's any kind of liability thing. Probably trying to insure that the bushing does not spin in the control arm. Three equal .500" long shots of TIG weld should suffice.
|
05-23-2017, 09:40 PM | #4 |
Junior Member
Join Date: Jan 2009
Location: Columbus, OH
Posts: 97
Likes: 0
Liked 2 Times in 1 Post
|
Re: Global West Bushing - weld or not?
Thanks for the replies. Is there a recommended shop in the Columbus area, I am north of Columbus.
|
05-24-2017, 09:12 AM | #5 |
Member
Join Date: Mar 2002
Location: Sullivan, OH
Posts: 302
Likes: 671
Liked 136 Times in 43 Posts
|
Re: Global West Bushing - weld or not?
Mine fit snug but I tacked them in place just to make sure they didn't move.
Are you looking for a shop to do the work or align it after the install?
__________________
Jon Sarrett Stock 3779 |
05-24-2017, 12:26 PM | #6 |
Junior Member
Join Date: Jan 2009
Location: Columbus, OH
Posts: 97
Likes: 0
Liked 2 Times in 1 Post
|
Re: Global West Bushing - weld or not?
I found a fabricator right around the corner from my place to weld it, who knew. I will eventually need a shop to align the front end.
|
|
|