M-200 torque converter installation

Bobby Zlatkin · 06-18-2016, 03:29 AM

Can't seem to get my torque converter back far enough onto the trans (M200) input shaft to give me space between the converter mounting pads and the flex plate so I can then pull the converter forward to bolt it down. (Damn, that was a long sentence) The converter is 3/4" back from the mating surface of the trans housing. Is that enough space? I am pretty sure I have the converter all the way into the trans (2 notches in).

I didn't have any problem with the last converter I used with this trans.

What am I missing here? Any help, thanks.

06-18-2016, 03:29 AM	#1
Bobby Zlatkin Member Join Date: Mar 2003 Location: Mills River, NC Posts: 417 Likes: 0 Liked 0 Times in 0 Posts	M-200 torque converter installation Can't seem to get my torque converter back far enough onto the trans (M200) input shaft to give me space between the converter mounting pads and the flex plate so I can then pull the converter forward to bolt it down. (Damn, that was a long sentence) The converter is 3/4" back from the mating surface of the trans housing. Is that enough space? I am pretty sure I have the converter all the way into the trans (2 notches in). I didn't have any problem with the last converter I used with this trans. What am I missing here? Any help, thanks. __________________ Bobby & Norene Zlatkin L/SA