|
10-14-2014, 11:19 PM | #51 |
Member
Join Date: Nov 2008
Posts: 457
Likes: 1
Liked 7 Times in 4 Posts
|
Re: Dan Fletcher Super Stock Videos - Opinions
Try removing the driveline and grease the splines on the yoke and make a hit .
__________________
Bob Aceves, 746 E/SA A&M motorsports |
11-24-2014, 12:27 AM | #52 |
Member
Join Date: Jun 2002
Posts: 175
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Dan Fletcher Super Stock Videos - Opinions
Did this problem get solved?
__________________
67 Ford Fairlane F/SA 749 |
11-24-2014, 06:07 AM | #53 |
Junior Member
Join Date: Aug 2009
Posts: 18
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Dan Fletcher Super Stock Videos - Opinions
I was told if you shut the car off and coast at the end of the run there is a lot of parts in the trans that arn't getting oiled since the the pump isn't being turned.
|
11-24-2014, 09:54 AM | #54 |
Member
Join Date: Dec 2005
Posts: 248
Likes: 291
Liked 129 Times in 24 Posts
|
Re: Dan Fletcher Super Stock Videos - Opinions
Dan,
If the bad heim doesn't fix it check the axles for runout. I had a drivers side axle bent that caused a bad vibration in the Mustang. Changed alot of stuff before I found it. Chucked both axles up in a lathe and could see it before I put the dial indicator on it. Good luck. rod |
11-24-2014, 12:03 PM | #55 |
VIP Member
Join Date: Jun 2008
Location: New Carlisle OH
Posts: 1,274
Likes: 3
Liked 394 Times in 181 Posts
|
Re: Dan Fletcher Super Stock Videos - Opinions
Hope you found the problem Dan and got it resolved by the way hows the new COPO Camaro doin ?
__________________
Jake Biermann |
|
|