Originally Posted by B Aceves (Post 389820)

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

Originally Posted by B Aceves (Post 389820)

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

Originally Posted by Bill Edgeworth (Post 389643)

To my knowledge Trend does not make a Pontiac lifter. Pontiac lifters are the same diameter as a Chevy but Pontiac ones are taller. Putting a Chevy lifter in a Pontiac can cause the oil gallery to become exposed at the top of the lifter when the lifter is on the base circle and or the lifter oil groove to become exposed on the bottom side. I can’t remember which it is, it’s been a few years since I decided to see if Chevy ones would fit. I would just use the Sherman lifters. If you really want to use ceramics I have a used set. I quit using ceramics years ago.

Originally Posted by B Aceves (Post 389820)

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

Originally Posted by Jeff Lee (Post 389720)

Guys, if something is not in a catalog, pick up the phone and ask. It's not that difficult! PPP just made me a set of AMC TS lifters and there were none in the catalog. I just sent them a lifter I wanted copied and in less than 4 weeks had a set. Didn't cost extra either. Now it's available for everybody.
If I sat around looking at catalogs for availability while building an AMC, I'd never get it done.

Originally Posted by brent flynn (Post 389884)

As Todd Hoven asked, will i need to run 130-ish on the seat? And what roughly , do these run, cost wise? They may be the way to go...do they lash, like a Schubeck? or do you preload them, a little?