CLASS RACER FORUM
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

CLASS RACER FORUM (https://classracer.com/classforum/index.php)
-   Stock and Super Stock Tech (https://classracer.com/classforum/forumdisplay.php?f=4)
-   -   Valve guide & spring seats on Stock heads. (https://classracer.com/classforum/showthread.php?t=56318)

Paul Precht 01-07-2015 01:01 AM
Re: Valve guide & spring seats on Stock heads.
 
Quote:
Originally Posted by Myron Piatek (Post 457673)
I did found a beehive spring I'd like to use. A standard spring with or without a damper wouldn't change anything. I'm just trying to get some sort of consistency as to what to expect in tech with the machined-off step - considering the rule change. Or if it's an "it depends on the tech guy". Hate to discard otherwise good heads if it's actually been allowed before.
I wish I remembered the person and configuration I saw with Chevy small block springs on a Mopar small block Stocker.

I've seen other similar rules discussed here allowing something new, but being unable to use it without doing posted illegal mods. The Edelbrock small block Mopar heads come to mind.
The small block Chrysler has a better foundation for springs than a small block Chev, not sure why anyone would do that, it would be a step backwards.

TurboBuick6 01-07-2015 10:27 AM
Re: Valve guide & spring seats on Stock heads.
 
You could machine a "Seat" to fill the void in the step, creating a flat surface for the spring, spring seat, ect. Basically a washer to just sit in the lower step and be flush with the upper step.

Myron Piatek 01-07-2015 12:49 PM
Re: Valve guide & spring seats on Stock heads.
 
After more research and talking to some people "in the know", the heads may not be legal because the spring seats may have been opened up (unnecessarily) during the guide & step machining. My engine guy will double-check, but I'll be looking for another set.

I'll get use to interpreting the rules as time goes on. But that's part of what this forum is for. Thank you for the opinions and suggestions.

njk53 01-07-2015 02:44 PM
Re: Valve guide & spring seats on Stock heads.
 
I was always under the impression that any spring including a beehive spring can be used so as long as no machine work of any kind can be performed to make a particular spring fit. We are using a beehive style spring on our BBC that fits using the original factory machined seat.

Myron Piatek 01-07-2015 04:27 PM
Re: Valve guide & spring seats on Stock heads.
 
Quote:
Originally Posted by njk53 (Post 457738)
I was always under the impression that any spring including a beehive spring can be used so as long as no machine work of any kind can be performed to make a particular spring fit. We are using a beehive style spring on our BBC that fits using the original factory machined seat.
Yes, I'm under the impression that is as as you describe. I was just a little surprised that they allowed "any" spring but no macining at all. I was hoping to use the otherwise good set of heads. OEM Mopar spring seats do accept certain beehives very well.


All times are GMT -4. The time now is 02:08 PM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.