| carl hinkson |
01-13-2016 11:39 PM |
Re: dart oil gallery
Quote:
Originally Posted by Ed Wright
(Post 492796)
Carl, I guess I have been lucky.
|
My self and alot of other guys who pay attention to detail have not been so lucky with there sizing.
Quote:
Originally Posted by Bolt
(Post 5118417)
I have to say, when Carl did my engine the lifters were a night mare. I can only speak for this one instance as it is the only lifters I bought.
They were all over the place in sizing. I called Isky they were nice enough about it, I sent them back, when Carl got the new ones they were still all over the map. So I called, they were nice about it, I sent them back again. When Carl got them for the third time and they were still all over the place in sizing, cost me $30.00 to ship them each time! Yep $90.00 in shipping, God knows because I cant remeber how much time I waited,the last set were close but had a lifter that was tapered.
It is what happened, so I hope they did get better about this issue, as it was some time ago. Now I wonder if I have the 8620 wheel, that would suck?
|
I probably see a few more lifters then you do, I have machined alot of lifter bores over the years and have seen about every lifter out there.
Go to the last post
https://www.facebook.com/cncblocks.n...02127783300404
Paying attention to details pays off and when you buy ISKY lifters that are not with in a .0015 or better this is what you might see.
https://www.youtube.com/watch?v=SpfOKr3B3FA |