CLASS RACER FORUM
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

CLASS RACER FORUM (https://classracer.com/classforum/index.php)
-   Stock and Super Stock Tech (https://classracer.com/classforum/forumdisplay.php?f=4)
-   -   bellhoushing (https://classracer.com/classforum/showthread.php?t=72461)

Stephen & Horace Johnson 03-13-2019 04:54 PM
Re: bellhoushing
 
Quote:
Originally Posted by Rory McNeil (Post 584600)
Stephen, do you have a QuickTime in the Fairlane? If so, with what clutch? I had heard that on a FE Ford the QuickTimes were not deep enough to work with a Long style pressure plate with a 10 or 10 1/2" disc, unless you stacked up block plates to get enough room. What is your experiance with the FE?
10in soft loc clutch. Did not have any issues . We lost a lot of weight over those lakewoods.

J&S Racing 03-13-2019 05:31 PM
Re: bellhoushing
 
Recently did my McLeod aluminum bellhousing. After fighting with the parallel I decided to remove the powder coating. Ended up being the ICT billet spacer I was using, it was off .010 from the dowel holes to the top. My concentric on the other hand was way off. I ended up using the Robbmc dowels.
https://i.imgur.com/HiZnriJ.jpg

Chevy55 03-14-2019 04:11 PM
Re: bellhoushing
 
As a old IH truck mechanic we were required to make three checks when there was a clutch disengagement problem.

1. flywheel parallel to the block (dial indicator on block, turn crank to check flywheel face)

2. face of Bellhousing parallel to the flywheel (dial indicator on flywheel, check bellhousing face when turning crank)

3. center hole in the bell matching the centerline of the crank.


All times are GMT -4. The time now is 04:03 PM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.