Locking Trans Dip Stick
 

Does anyone make a flex assembly that will pass the rule for locking transmission dip sticks. We currently run a unit purchased from Mancini Racing and the stick is sealed with o-rings and fits tight,hafta really tug on it, to get it out. The standard tube style will not work in our Avenger because the mid mount is in the way. Any suggestions?
Jeff Ross

Re: Locking Trans Dip Stick
 

I went to my local U-Pull It junkyard and got a couple locking dipsticks from newer GM vehicles. You can then cut and weld your dipstick to the locking one, remark the locking dipstick to your length or put your dipstick in your trailer and use just the locking portion of the locking dipstick in your dipstick tube if it is the same diameter.

Re: Locking Trans Dip Stick
 

In my Avenger i had the same issue! no room! i just installed a short dragster style it's fine. once you install the propper fluid amount no need to check it after that, so why have it in the way....

Re: Locking Trans Dip Stick
 

I think Lokar has a flexible locking dip stick for both engine and trans.

JimR

Re: Locking Trans Dip Stick
 

Jeff, The Lokar piece is the way to go.

Re: Locking Trans Dip Stick
 

Lokar has the set up for you.
the quick connect deal is the best. I can get you a good price on one if interested. Tim

Re: Locking Trans Dip Stick
 

Does Lokar have an application fot the 904 Torqueflites? I was on their website and did not see one.
Jeff Ross

Re: Locking Trans Dip Stick
 

Lokar has a flexible dip stick tube but its a pain to install. You have to remove the pan, so you can bolt it to the case. Of course it doesnt push in easy , you really have to work with it. I was replacing my non locking Lokar dip stick tube with the locking one and the bracket doesnt match up. So you have to drill new holes for the bracket. All this and its not easy to read, i dont know why other than the tube hangs so low in to the pan. But its flexible, its got that going for it. oh yea its also over $110

Re: Locking Trans Dip Stick
 

Thanks for all the different suggestions. I'm sure we can figure something out.
Jeff Ross

Re: Locking Trans Dip Stick
 

Jeff copy and paste!
http://www.lokar.com/interior_pages/transdipstick.htm