Originally Posted by 87gt50 (Post 83917)

When replacing the stock valves on E7TE heads, what is the prefered choice of brand? Any pros/cons on valve seals? Anything else to think about? Not looking to break any records, just want to use the proper parts and make it work as good as possible.

Thanks!

Joakim, Sweden

Originally Posted by 1664SSJA (Post 83948)

I like Ferreas, but if you need to have them cut down, have Ferrea do it. I think they charged 5 dollars a valve, and machine shop would be more. REMEMBER to DOUBLE CHECK the valves for size after they are cut, no matter who cuts them down.
Read the last sentence again. VERY IMPORTANT.

Originally Posted by Tom P (Post 84282)

Do those have the exhaust keeper groove in the higher position like the intakes or older 289-302 valves?

Originally Posted by 87gt50 (Post 84555)

Thanks to everybody for your input on this!
Another question on this subject is if sleeves should be used in the heads when replacing the valves?

Originally Posted by SSDiv6 (Post 84556)

I assume your are talking of bronze liners in the guides. Yes, they can be used; make sure the machine shop has the appropriate reamers and knows how to do it.

Originally Posted by SSDiv6 (Post 83934)

Manley:

Intake: P/N 11572-8
Exhaust: P/N 11523-8

Ferrea:

Intake: P/N F6261
Exhaust: P/N F6260

There are differences of opinion in the use of valve seals; myself, I prefer to use them. Hope this helps.