283 head gasket
 

Help
I cant remember the part # for the factory steel shim 283 head gasket.

Re: 283 head gasket
 

Dennis-The 307 head gasket {.017} I used was 3995633. Doug Schriener

Re: 283 head gasket
 

Thanks

Re: 283 head gasket
 

3830711 ???

Re: 283 head gasket
 

3830711 is a 4 inch bore.

Re: 283 head gasket
 

I'm sorry was
thinking what we used but yes the block was overbored---comp387

Re: 283 head gasket
 

FYI - I just ordered a set of Cometic gaskets. They'll make them any bore and the minimum thickness is .027".

Re: 283 head gasket
 

flat out will make them too--Comp387

Re: 283 head gasket
 

We use Cometics on our 283s (stockers). I reuse them in teardown multiple times. We used to run the shims, but they are hard to find. Tried Coppers and they were a pain. The Cometics are nice.

Re: 283 head gasket
 

Cometic tells me 100.00 each.
Chevy gasket 12.00 each.

Re: 283 head gasket
 

Well for whatever its worth Flatout is/was started and staffed by several of the Fel-Pro employees when Fel Pro scaled back their hi perf division which was about the time they went into bankruptcy and pretty much left the racing arena---Give em a call cant hurt---They won't BS you that's for sure---If they know the answer to your ??? they will give you the honest truth--- Cometic has a very good product to not bashing them at all---Comp 387

Re: 283 head gasket
 

Dennis 3995633 is the correct number they are .017 thick you may have to stack them depending on the deck

Re: 283 head gasket
 

The .017 number mentioned is the compressed thickness, right? What is the "squished" number when you stack 2 gaskets? I've heard that it's not necessarily .034, or did I hear wrong?

Re: 283 head gasket
 

I bought the 3995633 maybe 6 months ago but now are no longer available from gm. Did a little comparison with the 4.0 bore gasket and the difference in compression turns out to be almost nothing, 10.639 to 10.632. Looks like I will stock up on the bigger one.
Thanks for the help

Re: 283 head gasket
 

I have had this same part number gasket measure up to .019 Be very careful and double check your deck before calling it good. They are not consistant on thickness. Robin Brown also has seen this same type of variance....

Wade

Re: 283 head gasket
 

I spoke to the head of production at Detroit Gasket (the company that supplies Chevrolet with these gaskets) a few years ago about the steel shim gasket situation, and he said their dies are just too worn out to reliably produce good stampings for the 633 pn. He was willing to make another run if someone would belly up for 1000 gaskets and be willing to pay for culls. He said GM told him that the last batch he produced in 1999 would be the end for them because of low demand.

Re: 283 head gasket
 

Here are the Cometic Head Gasket choices for thickness. Jim

.027
.030
.036
.040
.045
.051
.056
.060
.066
.070
.075
.080
.084
.086
.089
.092
.095
.098
.120
.140