New Holley replacment carb.
 

I dont see this posted anywhere on NHRA's site. Is this info correct?
Travis, what do you know about this?

http://www.competitionplus.com/index...-stockss-legal

Re: New Holley replacment carb.
 

Interesting...if anyone was to make the same modifications to their current Holly carb, they would be tossed immediately.

http://www.competitionplus.com/image...ts/QFT_new.jpg

Re: New Holley replacment carb.
 

The carb pictured is from their Hot Rod series I believe. I don't know what the actual carb discussed in the article looks like.

I'd have to assume it doesn't really have screw in bleeds or an aluminum body!

Re: New Holley replacment carb.
 

Or the 4 corner idle system...Well, depending on who you are, you can get away with it on your current setup...Maybe its who you know in tech when they look at the carb?

Re: New Holley replacment carb.
 

This Carburator does have the screw in air bleeds and Technically not 4 corner idol. If you have any questions about this Carb, call Phillip Vickous at
270-793-0900. Thanks

Re: New Holley replacment carb.
 

Woodro, what do they do? get it close cut the screws off and silicone over the holes? LOL

Re: New Holley replacment carb.
 

where is this on the nhra page

Re: New Holley replacment carb.
 

So, just to clarify...

I get to dig through junkpiles and Ebay looking for a one-year-only POS Rochester 2bbl, and then try to figure out how to make it work, and what I can and can't do to it, but there's some combination that can just call up Quickfuel and order up a new-tech brandy new aluminum carb?

That seems pretty whack to me. I'm just sayin'.

PS Not faulting Quickfuel, they make awesome stuff.

Re: New Holley replacment carb.
 

LX you do know you do not need to run the right # carb dont you ? can be any # as long as it is the proper cfm and the throttle plates measures the same as original.

Re: New Holley replacment carb.
 

Bob:

I did not know that. Thanks!

I'm sure that will make the task easier. Does NHRA have those measurements somewhere?

Steve

Re: New Holley replacment carb.
 

Yes, under carb spec shows the mesurement

Re: New Holley replacment carb.
 

LX - What is your car / make / model / year and engine??

I've got quite a bit of original GM / RPD / AC Delco carb info and factory documentation.

Re: New Holley replacment carb.
 

So has the question been resolved? Can we run these carbs or what?

Re: New Holley replacment carb.
 

I was talking to one of my BBC Q-Jet racer buddies today. I told him for this carb he should convert to a 396/375 engine! I imagine QFT will sell a lot of S/SS carbs in the near future.

Re: New Holley replacment carb.
 

carb is NOT legal for stock
some ss classes

Re: New Holley replacment carb.
 

Today I was told by tech officials here at Lebanon Valley that the carb IS legal for Stock and Super Stock.
The carb in the picture from Comp Plus is NOT the carb.

This is the carb.
http://www.summitracing.com/parts/QF...0-VS/?rtype=10