TH-350, how long should the shift take.
 

What i mean is how long (in seconds) should the shifts take in a stocker prepped TH350. Judging by my datalogs its take .3 seconds. I am looking at the highpoint of first gear, to the lowest point immediately after the shift, same thing for the 2/3 shift. I am thinking it may be shifting slow, and thus losing some. any idea?

Re: TH-350, how long should the shift take.
 

Does your datalog also show RPM @ shift?

Re: TH-350, how long should the shift take.
 

yes it does. however what i am looking at is how long the trans actually takes to make the shift. I'm thinking it should be shifting quicker

Re: TH-350, how long should the shift take.
 

Sounds more like operator error rather than a mechanical issue. I'd put your dad back in the driver's seat!

Re: TH-350, how long should the shift take.
 

ouch! i was referring to internal transmission functions

Re: TH-350, how long should the shift take.
 

As apposed to bodily functions?

Re: TH-350, how long should the shift take.
 

Could you post you datalogger screen shot? I'd like to look at it I have a XLT 350 that I've been working on that had some issues. It would help to see what you're looking at. Joe

Re: TH-350, how long should the shift take.
 

.25 1-2 500 drop
.32 2-3 1208 drop

Bill

Re: TH-350, how long should the shift take.
 

Thanks Bill, on the 1-2 I'm assuming it goes back into the converter a bit? i know I've been shifting too high on ours, going to remedy that

Re: TH-350, how long should the shift take.
 

http://img.photobucket.com/albums/v6...68/datalog.jpg

the red line is the RPM