SS GT S-10 headers
 

Racers,

I am underway with the buildup. The combination is 327/300/293. This will be a "B" class truck.

Truck and much of the chassis needs in house. Engine parts being gathered.

So, about the headers. If you know someone racing an S-10 I need header feedback.

Thanks,

Re: SS GT S-10 headers
 

Check with FJ Smith.

http://www.smithperformance.com/catalogue_s10_sub.html

Re: SS GT S-10 headers
 

Lemons Headers has them. Pricey, but apparently good quality. I think you'll need the headers to setup the engine location though (at least that's what I gather from the website).

Wayne

Re: SS GT S-10 headers
 

Wayne, I have run Lemons on other cars and the fit is excellent, I will follow up. I also noted the engine location footnote and agree it would be wise to have headers bolted on before finalizing the motor plate tabs.

Re: SS GT S-10 headers
 

Larry… Check out Hedman part #'s 65854,65855,65856,65857 they are well constructed and cost effective. Maurice.

Re: SS GT S-10 headers
 

Maurice,

Thanks, I like value and will follow up.

Re: SS GT S-10 headers
 

Maurice,

With the fender well style what is the clearance situation with front tire?

Re: SS GT S-10 headers
 

Larry…The different part #'s represent primary tube dimensions and steps as well as collector diameters. They are also compatible with port plates and fully tig welded with removable collectors. MB.

Re: SS GT S-10 headers
 

With the engine in the correct position, things should work out (26-27" tire). What front tire diameter were you planning? Drop spindles? Ride height? These are all a determining factor. MB.

Re: SS GT S-10 headers
 

front tire size is flexible, it will depend on available room. So far, I see photos of the Hedman and Lemon designs.

I like the under car exit of the Lemons. The Hedman would need some extensions to direct the exhaust rearward. They would stir too much Texas dirt if pointed downward