Roller rocker arm and stud
 

What would be good a roller rocker arm and stud for a 396 350hp stocker. I am thinking of upgrading from the Holroyd setup.



Thanks. Bruce Cameron
E/S 68 Nova 396 350hp 4spd

Re: Roller rocker arm and stud
 

Check out the comp cams package.

13706-KIT
1820-16

http://www.compperformancegroupstore...Category_Code=

Re: Roller rocker arm and stud
 

I would just put on a set of Jesel shaft rockers. If you can get enough of your Stocker friends to do the same, NHRA will just make them legal, and you'll be all set. :rolleyes:

Re: Roller rocker arm and stud
 

I would most definitely look into a set of T&D s.
You won't be unhappy

Re: Roller rocker arm and stud
 

I have Harland Sharp on my engine combo that's the same as yours.

Re: Roller rocker arm and stud
 

I think the comp cams setup is very nice but a bit overkill on a lower hp 396. Also pretty pricey when you have buy the complete kit to get the 1/2" studs because they come with new 1/2" trunions etc. As you can buy the XD rocker arms setup for 1/2" studs already.

Re: Roller rocker arm and stud
 

The studs are available without the trunions and bearings and rebuild kit

comp 4543-16

overkill? depends upon how "square" of a lobe you are using and if one is "cheating" (who would do that) and is using a larger dia lifter to take advantage of that increased "rate"

edit..I understand Crower has a stock package out also...I have never seen that setup yet