th 350 ultra bell
r they worth the time & investment ? tks
|
Re: th 350 ultra bell
With what combination? Makes a difference...
|
Re: th 350 ultra bell
If your car has a tendency to break bellhousings, yes. I would recommend taking the trans case to a competent machinist so it can be cut and the bell housing be registered so that it can be installed properly.
|
Re: th 350 ultra bell
I wouldn't pull my trans out just to put one on , but if it's already out,its a no brainer,,considering the cost.
|
Re: th 350 ultra bell
There is absolutely NO need to install a ultra bell on your tranny...UNLESS you are cracking the case. After you have cracked ONE case,...it’s a lifesaver....of course my ole buddy Captain Jack cracked 2 cases before he bought the bell.....
|
Re: th 350 ultra bell
thankyou !!!
|
Re: th 350 ultra bell
Its the best way to go if you are in a class that requires a guard on the flywheel/ Bell housing. I have done several on Powerglides and they work real well.
|
Re: th 350 ultra bell
If you use a Bell that is easily removed and sent back for recert and a good quality Trans blanket, you'll save much $$ and frustration.....Worked for me!!
|
Re: th 350 ultra bell
They are nice and strong but they are also thicker and bigger. That might be a factor in a car with a stock floorpan transmission tunnel. I have a 3rd gen F body and the drivers side is very tight to the bell.
|
Re: th 350 ultra bell
the trans must come apart to install?
|
All times are GMT -4. The time now is 06:48 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.