Ford 302 Rocker Shims
 

Does anybody have a set that they could measure for me. I think they might work for my application, which looks similar.
Call or email me or just post the length , width and hole dia.
602-769-0346
myac455@gmail.com

Thanks

Re: Ford 302 Rocker Shims
 

.540 X .865 and the hole is not round, it's .320 X .345
Phil

Re: Ford 302 Rocker Shims
 

crane cams i believe has them...

Re: Ford 302 Rocker Shims
 

Mark,

What diameter and hole size do you need?

Prior to the rule change allowing aftermarket rocker arms, I used aircraft AN960 washers in Oldsmobile engine applications. They are available in 0.016, 0.032, 0.042 and 0.063 thickness. They are stronger than commercial washers and still low cost.

Re: Ford 302 Rocker Shims
 

Yes, I've seen those for Oldes. These are rectangular, and I will check out the info above from Phil. Thanks

Re: Ford 302 Rocker Shims
 

The aircraft AN960 washers are round and not rectangular. The engine did not know the difference. :D

Re: Ford 302 Rocker Shims
 

But it does.. Ford doesn't have any goofy bridges... The rectangle on the pedestal keeps the rocker on center ;-)

Re: Ford 302 Rocker Shims
 

I suppose you could use washers on a Ford but I'd prefer not to.

Re: Ford 302 Rocker Shims
 

Mark, Crane Cams Ford pedestal rocker shims 99170-1 Summit Racing. I use them on my Tempo pedestals.

Re: Ford 302 Rocker Shims
 

Ford Performance also has the pedestal shims ,part # M-6529-B302