Moser engineering axles, spool, hardware
 

I am a long-time, satisfied user of Strange Engineering products, but for this build-up on my Chevy Colorado, I am considering Moser. It is a Chevy 12 bolt, and I will need axles, spool, brakes, and other hardware.

Tell me about your experience with Moser products.

Re: Moser engineering axles, spool, hardware
 

I have their axles in my car since I built it in 1996 they still pay me contingency. I asked them if they wanted me to buy another set. Nope all good!!! I go 10.90@155-158 2800#s. I run almost every weekend. So the axles have thousands of runs! I would buy anything they offer. Oh yeah and they are only 35 spline too.
They also sponsor the moser shootout and used to help with special races In IHRA too.

Re: Moser engineering axles, spool, hardware
 

When I started building my 85 Mustang Stocker, I went with a pair of Moser 31 spline axles, simply because I found a new pair in the local classifieds for $150., in the box. I added a Moser spool, C Clip eliminators, and a girdle cover. Also welded the tubes to the center casting. This was a 4 speed car, weighed 3090 for M, 3185 for N, ran the car in Stock for 10 years, then 3 years with a low 10 second bracket engine (still with the 4 speed), I broke a couple of ring and pinions, but never hurt the axles. Not as pretty as the Strange stuff in my other car, but the Mosers were great, especially for the price.

Re: Moser engineering axles, spool, hardware
 

We run primarily Moser stuff in most of our dozen racers over
the years and have encountered Zero issues for 20+ years!

Re: Moser engineering axles, spool, hardware
 

I have Moser axles and spool in an 8 3/4 Mopar diff, been in there since '97, many passes, 4 ring and pinions, but the Moser stuff still perfect.

Re: Moser engineering axles, spool, hardware
 

Moser pays at div and nationals,strange only at nationals

Re: Moser engineering axles, spool, hardware
 

When I needed axles a couple of years ago I believe Strange said it was about a 6 week lead time. Moser sent the axles out the next day at a much lower cost!

Re: Moser engineering axles, spool, hardware
 

Good People. Fair prices. Couple of years ago I needed a center chunk for one of my drag packs. Got Larry Cummins to call them for me and picked it up in Indy. Just good people. Jeff

Re: Moser engineering axles, spool, hardware
 

Just bought a set of axles,Ring and Pinion and other goodies this past year and am very satisfied.

Re: Moser engineering axles, spool, hardware
 

Had a Mark Williams spool from my modified eliminator days. They cut the same MW spline on the Moser axles I bought in 1996. 35 spline both still in use today.