Dual Point Corvette Distributor
 

Looking for a set of points for my dual point distributor, anyone have any leads or part numbers. The distributor is cast iron early corvette and has the tach drive.
Thanks

Re: Dual Point Corvette Distributor
 

Back in the day, D112P was the Delco part number we all used ….tell me you are not using this in your stocker……

Re: Dual Point Corvette Distributor
 

NAPA has them.
Bob

Re: Dual Point Corvette Distributor
 

fyi .. the Holley website shows their Accel ignition division shows a heavy duty / strong spring pressure points / condenser / clamp part # available for gm distributors

Re: Dual Point Corvette Distributor
 

If my memory is doing right I think the best set back in the day were made by Mallory.
Think they had an X in the part number. for extra spring tension.
Sure beat doing the double spring modification.

Re: Dual Point Corvette Distributor
 

Good morning,
I believe the Good Accel points were #110129 and the regular Street points were #110128.
The Mallory points were #102X - these were the Heavy Duty race points they would go 10,000 RPM on my old Sunnen Distributor machine. I used the old Accel #110129 points till I couldn't get them anymore, are they still available under a different part? Thanks in advance.

Respectfully,
Henry Kunz 1534 H/SA

Re: Dual Point Corvette Distributor
 

No it's not for my stocker, Have a 1967 Camaro street car was looking to freshen up the distributor. The car was put back on the street in 1999 and haven't done anything since then to it, Thanks for the part number

Re: Dual Point Corvette Distributor
 

Thanks I'll check them out

Re: Dual Point Corvette Distributor
 

OK, you are good to go then Mark,….LOL ….