CLASS RACER FORUM - View Single Post

Jim Cimarolli · 04-27-2009, 10:56 PM

Yeah I ran into the same problem before. If the hub isn't honed to fit before it is installed the sob is almost impossible to get off. What I did was put all the meat on the puller that it will stand, then hit the end of the drive bolt with a big hammer, it should jar the darned thing just a bit, then run the bolt in a bit more and keep hitting it.

Good luck.

04-27-2009, 10:56 PM	#2
Jim Cimarolli Senior Member Join Date: Mar 2002 Location: Sulphur Springs Texas Posts: 743 Likes: 146 Liked 166 Times in 46 Posts	Re: Balancer removal Yeah I ran into the same problem before. If the hub isn't honed to fit before it is installed the sob is almost impossible to get off. What I did was put all the meat on the puller that it will stand, then hit the end of the drive bolt with a big hammer, it should jar the darned thing just a bit, then run the bolt in a bit more and keep hitting it. Good luck.