[Aubrey N Bruneau]

Thanks Al... good point
Rockers are on now. All's good. Geometry is dead on.

I actually had a bit of an issue with the stamped steel rockers when I assembled the engine. These new Manton pushrods have a different tip than normal, and I found all the intake rockers getting "bumped" on the inner/underside, by the pushrod, when near full lift. I had to take my die grinder, and create an ever-so-slight little "pocket", so the pushrod would not touch it.

The other thing too, is that my valve lift is very near my maximum, and changing pushrods... especially if slightly longer, could put my lift over the top.