CLASS RACER FORUM - View Single Post - Stock Eliminator

Ben Kallies · 07-23-2009, 11:31 AM

I have a question regarding the new valve job rule that states: Any valve job allowed. Can I assume that this rule allows for back-cutting the valve to match the angles cut in the head? For instance, if I choose to do a 5-angle valve job instead of the old 3-angle, I would need to cut to the valve to match. Is this allowed? I didn't see it mentioned specifically in the rule book. Thank you.

-Ben

07-23-2009, 11:31 AM	#1
Ben Kallies Member Join Date: Jan 2005 Location: Milwaukee, WI Posts: 107 Likes: 2 Liked 0 Times in 0 Posts	Stock Eliminator - Any Valve Job? I have a question regarding the new valve job rule that states: Any valve job allowed. Can I assume that this rule allows for back-cutting the valve to match the angles cut in the head? For instance, if I choose to do a 5-angle valve job instead of the old 3-angle, I would need to cut to the valve to match. Is this allowed? I didn't see it mentioned specifically in the rule book. Thank you. -Ben