CLASS RACER FORUM - View Single Post

bubski · 12-24-2009, 05:32 PM

like alan said any cut and depth concentric to guide. however if cc is not a issue and you have access to a flow bench do some r/d with the bowl hawg and see what happens you may be surprised as you may lose some low .2 .3 numbers and pick up around .4 .45 lift about out of the lift range of a stock cam however the flow bench is not the engine and ive seen some heads bowlhawged to death with horrible low .2 .3 flow # and still run fast . however stock is a free for all now and youre chances of being tossed out of tech slim you have a better chance at getting bounced if youre heads are too stock. merry christmas.

12-24-2009, 05:32 PM	#7
bubski Member Join Date: Dec 2009 Posts: 228 Likes: 14 Liked 165 Times in 60 Posts	Re: Valve Job Question like alan said any cut and depth concentric to guide. however if cc is not a issue and you have access to a flow bench do some r/d with the bowl hawg and see what happens you may be surprised as you may lose some low .2 .3 numbers and pick up around .4 .45 lift about out of the lift range of a stock cam however the flow bench is not the engine and ive seen some heads bowlhawged to death with horrible low .2 .3 flow # and still run fast . however stock is a free for all now and youre chances of being tossed out of tech slim you have a better chance at getting bounced if youre heads are too stock. merry christmas.