CLASS RACER FORUM - View Single Post

Shawn Blair · 02-19-2010, 12:44 PM

What spline axle's are you running and what's your bearing OD? I run 40 spline Mark Williams axle's in my car and you have to use there housing end's because the bearing is bigger. This might be your problem. These end's have the Mopar 5 bolt pattern just a bigger ID for the bearing. How i got the Wilwood brackets to work was, I took a stock Mopar housing end and bolted the bracket to the end and chucked it up in the lathe. Then cut the recess in the bracket to take the larger bearing, just make sure you don't cut the recess deeper just open up the OD! Hope this helps

Shawn

02-19-2010, 12:44 PM	#9
Shawn Blair Member Join Date: Dec 2007 Location: Everson, WA. Posts: 122 Likes: 1 Liked 0 Times in 0 Posts	Re: Dana 60 axle bearing part II What spline axle's are you running and what's your bearing OD? I run 40 spline Mark Williams axle's in my car and you have to use there housing end's because the bearing is bigger. This might be your problem. These end's have the Mopar 5 bolt pattern just a bigger ID for the bearing. How i got the Wilwood brackets to work was, I took a stock Mopar housing end and bolted the bracket to the end and chucked it up in the lathe. Then cut the recess in the bracket to take the larger bearing, just make sure you don't cut the recess deeper just open up the OD! Hope this helps Shawn __________________ Shawn Blair 6383 SS 634 STK