CLASS RACER FORUM - View Single Post

Jeremy · 08-15-2010, 07:59 AM

No machining, just shimed the bottom step level. These springs last well and have a low height set up. You can get about any pressure you would like.

Many small block Chevys are using this spring with success in Stock.

At the time I was using these I had a longer than stock valve, I'm not sure how the heights will work out with stock length valves.

08-15-2010, 07:59 AM	#6
Jeremy Junior Member Join Date: Dec 2002 Posts: 95 Likes: 0 Liked 1 Time in 1 Post	Re: SB Mopar Valve springs? No machining, just shimed the bottom step level. These springs last well and have a low height set up. You can get about any pressure you would like. Many small block Chevys are using this spring with success in Stock. At the time I was using these I had a longer than stock valve, I'm not sure how the heights will work out with stock length valves. Last edited by Jeremy; 08-15-2010 at 08:10 AM. Reason: Forgot something