CLASS RACER FORUM - View Single Post

StockerRook · 09-28-2010, 10:58 PM

Hey Everyone,

I had a quick question. We are about to clean up a LT1 block that i have for a stocker motor. Give it a minimum bore to clean the cylinder walls. I had heard something about a Bore alignment tool that uses the dowel pins on the back of the block. Does this ring a bell with anyone?

If so, is it necessary to use or am i being over-picky? Where could i find or borrow one. Any help would be appreciative. Thanks in advance.

Chris

09-28-2010, 10:58 PM	#1
StockerRook Junior Member Join Date: Jan 2009 Posts: 36 Likes: 0 Liked 0 Times in 0 Posts	Bore Alignment Tool Hey Everyone, I had a quick question. We are about to clean up a LT1 block that i have for a stocker motor. Give it a minimum bore to clean the cylinder walls. I had heard something about a Bore alignment tool that uses the dowel pins on the back of the block. Does this ring a bell with anyone? If so, is it necessary to use or am i being over-picky? Where could i find or borrow one. Any help would be appreciative. Thanks in advance. Chris