CLASS RACER FORUM - View Single Post

cad · 11-12-2010, 03:14 PM

I ordered mine at 0.
While at the ET Finals in Topeka this year, I had my extra set of 15x8 Weld Drag Lites with me.
I had the Hoosier rep mount one 30x9 Hoosier Radial slick on it and I trial fitted it. It fit perfect as far as height goes.

Something isnt right on my quarters or rear end....My LH qtr panel was not installed the same as the RH side, so I need to do some measuring before I could run a slick that tall. It was too close to the front on the LH side.

You can always lower and raise with a spacer, if you start at zero.
I believe Calvert will exchange them for free if you are not content.
Give Travis or John a call. They will set you up right.

Clark

11-12-2010, 03:14 PM	#4
cad Senior Member Join Date: Apr 2009 Location: Omaha, NE Posts: 703 Likes: 203 Liked 93 Times in 52 Posts	Re: 68 camaro stocker rear suspension I ordered mine at 0. While at the ET Finals in Topeka this year, I had my extra set of 15x8 Weld Drag Lites with me. I had the Hoosier rep mount one 30x9 Hoosier Radial slick on it and I trial fitted it. It fit perfect as far as height goes. Something isnt right on my quarters or rear end....My LH qtr panel was not installed the same as the RH side, so I need to do some measuring before I could run a slick that tall. It was too close to the front on the LH side. You can always lower and raise with a spacer, if you start at zero. I believe Calvert will exchange them for free if you are not content. Give Travis or John a call. They will set you up right. Clark