CLASS RACER FORUM - View Single Post

Peter Ash · 01-08-2011, 03:52 PM

If any part needs surface lapping. It should be done in a figure "8" pattern on a surface plate(glass or a highly finished checkerboard steel lapping plate). This is how I was taught when we used to rebuild fuel injection components.

Peter

01-08-2011, 03:52 PM	#6
Peter Ash Member Join Date: Jan 2010 Posts: 262 Likes: 2 Liked 0 Times in 0 Posts	Re: Small Block Mopar Thrust Bearing issue If any part needs surface lapping. It should be done in a figure "8" pattern on a surface plate(glass or a highly finished checkerboard steel lapping plate). This is how I was taught when we used to rebuild fuel injection components. Peter Last edited by Peter Ash; 01-08-2011 at 10:24 PM.