CLASS RACER FORUM - View Single Post - Oil Expander Ends

CraigG · 08-15-2011, 04:51 PM

Hey Everybody,

I aligned all the rings according to the Sealed Power instruction sheet. When I installed all of the pistons - 2 or 3 of them ended up with the the oil ring assembly being rotated so that the expander end gaps were pointed toward the pin. The Oil Scraper ring ends are all spaced correctly.

Well, would you take it all apart to re-postion that oil ring assembly?

Thanks Again, Craig

08-15-2011, 04:51 PM	#8
CraigG Junior Member Join Date: May 2007 Location: Iowa Posts: 40 Likes: 0 Liked 8 Times in 7 Posts	Re: Oil Expander Ends - Positon/Phasing on Piston Important? Hey Everybody, I aligned all the rings according to the Sealed Power instruction sheet. When I installed all of the pistons - 2 or 3 of them ended up with the the oil ring assembly being rotated so that the expander end gaps were pointed toward the pin. The Oil Scraper ring ends are all spaced correctly. Well, would you take it all apart to re-postion that oil ring assembly? Thanks Again, Craig