Quote:
Originally Posted by carl hinkson
We CNC machine all our blocks and we also have the ability to probe the lifters bores for locations and we have not found any problmes with the ones we have checked!!
|
Carl
Long time since I spoke with you. If you remember we talked eons years ago about reworking small block oil pumps. I to have CNC capability with two machines. I purchase a few Dart blocks and Bowtie blocks as well as PBM. I have 1 SHP and 2 Little M and a Big M and a Bowtie here now. But I do not purchase enough to buy direct at a great cost, so I purchase from a good vendor that handily takes care of me( they sort thru a larger inventory than I could ever keep to help me). Have you had the opportunity to check the SHP after several runs (circle tracks) and saw any problems with their integrity as compared with the Little M.. Have you noticed the inability to keep seal after severe use and walking around of the mains.
reed