CLASS RACER FORUM - View Single Post

7423 · 06-02-2012, 11:34 PM

[QUOTE

also under the cylinder heads section it says:

"The following are permitted: polylocks, jam nuts, screw-in larger diameter rocker studs, or pinned studs..."

I'm finishing up a stocker 5.0 Mustang. Using stock rockers, not rollers, would you say that screw-in studs are legal? I'm getting conflicting feedback on this.

Thanks[/QUOTE]

Screw in studs are legal if they screw into the original 5/16" course thread holes in the pedastal. I assume that is not the answer you were looking for. I confronted Bruce with this topic a couple years ago.

06-02-2012, 11:34 PM	#16
7423 Senior Member Join Date: Dec 2006 Posts: 639 Likes: 0 Liked 1 Time in 1 Post	Re: Legal Ford 5.0 head with screw in studs [QUOTE also under the cylinder heads section it says: "The following are permitted: polylocks, jam nuts, screw-in larger diameter rocker studs, or pinned studs..." I'm finishing up a stocker 5.0 Mustang. Using stock rockers, not rollers, would you say that screw-in studs are legal? I'm getting conflicting feedback on this. Thanks[/QUOTE] Screw in studs are legal if they screw into the original 5/16" course thread holes in the pedastal. I assume that is not the answer you were looking for. I confronted Bruce with this topic a couple years ago. Last edited by 7423; 06-02-2012 at 11:37 PM.