CLASS RACER FORUM - View Single Post

Philip Baise · 10-28-2013, 11:03 AM

Try this, On the sec. shaft there is a screw that will help adjust the idle. With a 3/32 allen wrench turn this screw 1/4 turn counter clockwise, then adjust your idle on the primary side to compensate for that . Mixture screws in the sec. should be 1 and 1/2 turns out. The primary screws can be 1 or 1 1/2 out (which ever is best for you. And the bleeds were staggered on purpose, 73 pri, 68 sec. Hope that helps.

10-28-2013, 11:03 AM	#11
Philip Baise Junior Member Join Date: May 2003 Location: Griderville Posts: 33 Likes: 3 Liked 0 Times in 0 Posts	Re: Carburetor idle air bleeds Try this, On the sec. shaft there is a screw that will help adjust the idle. With a 3/32 allen wrench turn this screw 1/4 turn counter clockwise, then adjust your idle on the primary side to compensate for that . Mixture screws in the sec. should be 1 and 1/2 turns out. The primary screws can be 1 or 1 1/2 out (which ever is best for you. And the bleeds were staggered on purpose, 73 pri, 68 sec. Hope that helps.