[FED 387]

MARK ---this is the shop manual way of doing it
TO REMOVE
1) Disconnect negative battery cable
2) Unclip hoses from the inner fender
3) Disconnect the electrical feed to blower motor
4)Turn the front wheels to the extreme right
5) Remove the inner fender retaining bolts allow the inner fender to rest on the tire & use a block of wood to position fender away from the firewall
6)Remove the screws attaching the blower mounting plate to the air inlet housing
7)Remove the screws attaching the blower motor to the mounting plate
8)Remove the clip attaching the cage to the shaft & remove the blower motor
TO INSTALL
1)Position the blower motor in the vehicle then install the attaching clip to the cage & shaft
2)Install and tighten the screws attaching the motor to the mounting plate, then install & tighten the screws attaching the mounting plate to the inlet housing
3)Reposition the inner fender removing the block of wood and secure using the retaining bolts
4)Attach the electrical feed to blower motor
5)Attach the hoses in the clip
6))Re-attach the negative battery cable
7) Check blower for operation

hope this helps--FED387