CLASS RACER FORUM - View Single Post

Bill Diehl · 12-13-2013, 04:15 PM

Valve seats.....when installing new seats can you blend in the ridge in the casting at the bottom of the seat?

Is the Quick Fuel SSR-780-VS an acceptable replacement for the D0ZF 9310-Z Holley 4653?

Can an adjuster be installed on the pushrod side of the rocker arm

Can floor mounted clutch linkage be installed?

Can the block be machined for 42/46 lifter phasing?

Thanks

12-13-2013, 04:15 PM	#1
Bill Diehl Member Join Date: Dec 2013 Posts: 311 Likes: 2 Liked 9 Times in 8 Posts	351C questions Valve seats.....when installing new seats can you blend in the ridge in the casting at the bottom of the seat? Is the Quick Fuel SSR-780-VS an acceptable replacement for the D0ZF 9310-Z Holley 4653? Can an adjuster be installed on the pushrod side of the rocker arm Can floor mounted clutch linkage be installed? Can the block be machined for 42/46 lifter phasing? Thanks