CLASS RACER FORUM - View Single Post

Run to Rund · 07-26-2014, 12:02 PM

0.312" is "standard" 5/16" and mine show no signs of wear that I could see with the shifter lever removed. I am probably easier on the trans than most, and have used it less since 2007 than many racers in 1/2 season. The slot in the shifter lever also measured .312" minimum, with a little variation of course because the slot was punched by Hurst/Mr. Gasket.

07-26-2014, 12:02 PM	#51
Run to Rund Senior Member Join Date: Sep 2007 Location: Henderson, NV Posts: 583 Likes: 8 Liked 54 Times in 27 Posts	Re: Anyone have a shift finger for Jerico? 0.312" is "standard" 5/16" and mine show no signs of wear that I could see with the shifter lever removed. I am probably easier on the trans than most, and have used it less since 2007 than many racers in 1/2 season. The slot in the shifter lever also measured .312" minimum, with a little variation of course because the slot was punched by Hurst/Mr. Gasket.