CLASS RACER FORUM - View Single Post - Wanted: Cap for Holley Billet Distributor

Larry Merk · 10-09-2014, 08:18 PM

Thanks for the suggestions to all who replied.

We've gone to several local parts houses and gone through the parts books with some of their "seasoned" personnel and looked at quite a few distributor caps. Some are very close, but all were either a bit too tall or the diameter was off by 1/8 of an inch or more. A tech rep from Accel tried to cross reference the Holley part number with no luck.

Attached are a few pictures of the cap with a broken terminal. The cap measures 3 7/8 inches outside diameter at the bottom of the cap, 3 9/16 inches inside diameter at the inside mounting surface, and about 3 inches tall.

Still looking and willing the chase any lead anyone can offer.

10-09-2014, 08:18 PM	#7
Larry Merk Member Join Date: Aug 2010 Location: Kennewick, WA Posts: 213 Likes: 47 Liked 314 Times in 113 Posts	Re: Wanted: Cap for Holley Billet Distributor Thanks for the suggestions to all who replied. We've gone to several local parts houses and gone through the parts books with some of their "seasoned" personnel and looked at quite a few distributor caps. Some are very close, but all were either a bit too tall or the diameter was off by 1/8 of an inch or more. A tech rep from Accel tried to cross reference the Holley part number with no luck. Attached are a few pictures of the cap with a broken terminal. The cap measures 3 7/8 inches outside diameter at the bottom of the cap, 3 9/16 inches inside diameter at the inside mounting surface, and about 3 inches tall. Still looking and willing the chase any lead anyone can offer. Attached Thumbnails __________________ Larry Merk