Quote:
Originally Posted by foxy343
Sorry guys,
I was specifically asking how you run the safety belts to the rear bar on a high back bucket - stock seat. How do the belts stay up, and how do they keep being supported. I saw a few years back someone had cut an access hole in the seat for the belts to pass through. Is this legal, or is there another way to do this before cutting a hole in the stock seat? My solution was to make a n aluminim bracket to support seat and support belts at the same time. Thanks for replys
|
That's the issue that prompted me to ditch the stock seats. The belts were held in position at the roll bar by a steel bar that kept the attachment points behind me, but the belts could still slip off my shoulders. I might have cut slots into the seats to feed the belts through but it didn't look like that would work on my seats (2nd gen Camaro). So I went to aftermarket seats with shoulder belt slots, and I'm much happier and more secure now.
And I did build that brace from the headrest to the roll bar, so it's a nice solid mount now.