CLASS RACER FORUM - View Single Post

Adger Smith · 11-01-2014, 02:46 PM

Bill, if it has had any angle milling at all the face needs to be milled to get the angle corrected. Even flat milling the head the intake surface needs milling for the intake to fit in the valley. I would say the odds are pretty good that there are very few that haven't had the intake surface milled.

11-01-2014, 02:46 PM	#108
Adger Smith VIP Member Join Date: Dec 2001 Location: Texarkana Ark/TX Posts: 2,446 Likes: 575 Liked 880 Times in 311 Posts	Re: Stocker Cylinder Heads.... Bill, if it has had any angle milling at all the face needs to be milled to get the angle corrected. Even flat milling the head the intake surface needs milling for the intake to fit in the valley. I would say the odds are pretty good that there are very few that haven't had the intake surface milled. __________________ Adger Smith (Former SS) Last edited by Adger Smith; 11-01-2014 at 02:48 PM. Reason: sp