View Single Post
Old 12-24-2014, 12:11 PM   #7
Eman
Member
 
Join Date: May 2014
Location: E TN
Posts: 473
Likes: 16
Liked 133 Times in 76 Posts
Default Re: Pulling trans from DF/S 91 Olds Delta 88 Help

Unless the frame has been modified it unbolts at the Rt. frt. You remove the bolts at the rt. frt. and the frame mount at the LF and LR and that half comes out. You have to break the ball joints to remove the axles easily. You can leave the L ball joint attached and swing the frame out, flat rate time saver. I use a support that goes from fender to fender and holds the motor up. You can make a support and use a long J bolt so you can hook the motor and raise or lower it, helps aligning everything.
Eman is offline   Reply With Quote