Quote:
Originally Posted by rod butcher
Bob,
Is the brass plate for metering rods in place? If that slips forward when changing metering rods it will bog with spill-over. Also check choke pull-off.
rod
|
That is the problem which I had...
I did not know that it was there and, when I pulled the secondary rods to measure them to resolve a rich condition, it slipped forward.
I could not understand how a car, which ran fabulously just two weeks before, could now stall after my burnout and hesitate so bad off the line.
As it was my first experience with a Danny Ashley carb, I did not find it until I pulled the top off.